How to compress images for your website without visible quality loss
By PulseTech Editorial · Published 20 November 2026
Images are usually the heaviest part of a web page. Trimming them is the quickest way to make a site load faster, and it is easier than it sounds if you do the steps in the right order.
1. Resize before you compress
A photo straight from a phone can be 4000 pixels wide. If your page shows it at 800 pixels, the extra pixels are wasted bytes. Use the Image Resizer to set the width to about twice the display size, which keeps it sharp on high-density screens.
2. Choose the right format
- JPEG suits photographs.
- PNG suits screenshots, logos and anything with sharp edges or transparency.
- WebP is usually 25 to 35 percent smaller than JPEG or PNG at similar quality and works in all current browsers.
Convert with the Image Converter if your files are in an older format.
3. Lower the quality a little
Open the Image Compressor and start at a quality of 75 to 80. At that level most photos look the same to the eye while losing a large share of their size. Compare the before and after at full size. If you see blocky patches in smooth areas such as sky, raise the quality by five and try again.
4. Check the result
Look at the saved percentage next to each file. A photo that only shrinks by a few percent was probably already compressed. Do not compress the same file repeatedly, because each pass loses detail.
A simple rule of thumb
For a typical blog image, aim for under 200 KB. For a full-width hero image, under 400 KB is a reasonable target.